Set the following for initial testing: | DIP Switch | Setting | Function | |------------|---------|----------| | SW1 | OFF | Pulse count = 1 (most sensitive) | | SW2 | OFF | Pulse count = 1 (continued) | | SW3 | ON | LED enabled (useful for walk testing) | | SW4 | OFF | Normal alarm output |
The Input/Output (I/O) configuration is the next logical step. The R2D272 likely features a combination of analog and digital I/Os. The installer must terminate these connections according to the specific schematic of the facility. For instance, connecting a 4-20mA sensor to a voltage input terminal will result in immediate hardware damage. This phase demands a "measure twice, cut once" philosophy. It is best practice to perform a continuity check on all harnesses before powering up the unit to ensure no short circuits exist. aqmos r2d272 installation new
: The BNT 1650 electronic valve is factory preset, but users must still input their local water hardness and current time. Some find the initial programming instructions or manufacturer videos slightly confusing but manageable once understood. Physical Requirements Set the following for initial testing: | DIP